Cabinet Planner
General >> Cabinet Planner >> Face Frame Cabinets
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1404804726
Face Frame Cabinets
Post by snookhooked on Jul 8th, 2014, 01:32am
Rob,
I am wanting to do full run of cabinets face frame not individual cabinets like European but the box sizes would be different both in height and width. I cant seem to alter the different sizes in a face frame. it would have to be done like euro cabinets with each box separated the connected together for a full face frame. is there a way to do this. Its old school building how you have a 17 inch a 30 inch over the stove and a 22 inch all in one cabinet with a face frame. does that make any sense to you?
Re: Face Frame Cabinets
Post by Rob on Jul 8th, 2014, 08:46am
http://www.cabinetplanner.com/manual_7.html
Re: Face Frame Cabinets
Post by snookhooked on Jul 12th, 2014, 10:25am
Rob,
I didn't explain my question correctly. I was asking in the term of one run of cabinets ( 3 cabinets built old school together) that meaning that all 3 cabinets would be as one full unit not 3 separate boxes as the program normally does them like European that are screwed together in the end. It would save on material cost. is there a way or do I just need to remove some sides and add in the extra length in bottom material?
Re: Face Frame Cabinets
Post by Rob on Jul 12th, 2014, 3:14pm
Did you not read the page linked to above? What you describe is exactly what that page is about. In the photo below, the 3 cabinets are combined into one unit.
Re: Face Frame Cabinets
Post by snookhooked on Jul 13th, 2014, 08:17am
Sorry, my bad. I ran through it quickly and took it wrong. Thx