Cabinet Planner
General >> Cabinet Planner >> Bottom Size ProblemRob,
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1260494740

---

Bottom Size ProblemRob,
Post by JT on Dec 10^th, 2009, 6:25pm

---

Re: Bottom Size ProblemRob,
Post by Rob on Dec 10^th, 2009, 7:14pm

---

Re: Bottom Size Problem
Post by JT on Dec 11^th, 2009, 07:57am

Well, let me try again ... you gotta love computers!

Rob,

I designed a bar with all lower cabs and then printed off the layouts. When I was cutting the project I noticed that the bottoms were all 3/4" to long and hadn't been narrowed to allow for the back. I check the standards but couldn't see anything there to correct this. Is there something that I am missing?

JT

---

Re: Bottom Size ProblemRob,
Post by Rob on Dec 11^th, 2009, 10:27am

For the bottom length it sounds like the “dado depth” is set to 3/8” and you don’t use dados. Go to the General Standards, set it to zero and then press the “Apply to current job” button.

Do you have a value entered for the “inset back depth”? This will decrease the depth of the bottoms.

---

Re: Bottom Size ProblemRob,
Post by JT on Dec 11^th, 2009, 2:05pm

Rob,

The dado depth was the problem with the length. Thank you.
The amount that back is recessed is set at 1/2" but isn't adjusting the width. I tried setting it to 3/4" and it took 1/4" off the width.

JT

---