Cabinet Planner: End panels

Cabinet Planner
General >> Cabinet Planner >> End panels
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1271691495

End panels
Post by buzzymcgraw on Apr 19^th, 2010, 09:38am

Rob, I'm trying to add a 3/4 end panel to the side of an upper cabinet but when i click on panel sides it says "there are no panels in this job". Am I going about it the wrong way? Also is there a way to add roll outs to a standard base cabinet? TIA
Jon

Re: End panels
Post by Rob on Apr 19^th, 2010, 10:14am

The "Panel sides" button is for adding a raised panel to the side of a cabinet. You need to create one of the proper size before you can add it to a cabinet.

If you're looking to add a flat panel to the side of a cabinet you will need to use an "Upper Filler" for this as a separate unit.

Re: End panels
Post by buzzymcgraw on Apr 19^th, 2010, 12:17pm

Thanks Rob- any ideas on adding roll out drawers to a base

Re: End panels
Post by Rob on Apr 19^th, 2010, 2:58pm

Sorry, the program doesn't have roll out trays.