Cabinet Planner
General >> Cabinet Planner >> Top and Bottom not the same depth as sides
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1436206121

---

Top and Bottom not the same depth as sides
Post by CNCWoodworking on Jul 6^th, 2015, 12:08pm

I want to inset the back into the sides as well as the top and bottom but the top and bottom depth is always less than the depth of the sides by the entry in the "Inset Back Depth". And the DXF output does not have the boxes for the rabbets on the top or the bottom (likely because of the depth). The sides are calculated correctly including the rabbet box in the dxf output. Can CP accommodate this and if so, how?

---

Re: Top and Bottom not the same depth as sides
Post by Rob on Jul 6^th, 2015, 3:55pm

You can use the top & bottom depth adjustments in the 'cabinet parts adjustment' window to get them full depth.

The dxf file is not setup to create rabbits for the tops & bottoms, sorry.

---

Re: Top and Bottom not the same depth as sides
Post by timberlinemd on Feb 3^rd, 2016, 7:00pm

Yes, a fully rabbited back in the upper cabinets would be nice in the DXF file

---