Cabinet Planner - help with doors

Cabinet Planner

General

Cabinet Planner (Moderator: Rob)

help with doors

« Previous Topic | Next Topic »

Pages: 1

Author

Topic: help with doors (Read 387 times)

n7kon
New Member

member is offline

Posts: 7

help with doors
« Thread started on: Jun 23^rd, 2017, 2:24pm »

I have a door opening that is 18 wide x 20 tall when I print out the parts sheet it shows the door rails at 15.75 rails. stiles are 2.375 wide with a .375 long tenon plus it shows a flat panel of 14.75 x 16.75 that panel would be too small for a 15.75 wide rail. I have door standards set for 2.375 widths on stiles and rails and the .375 tenon length.
When you do the math by hand the rails should be 15" for a .5 overlay. What do I have setup wrong?

Logged

n7kon
New Member

member is offline

Posts: 7

Re: help with doors
« Reply #1 on: Jun 23^rd, 2017, 5:21pm »

ok took out cutting length in door standards and rails go to 15" but the panel is still 14 x 16 what changes do I make for the panel size?

Logged

Rob
Administrator

member is offline

Gender:

Posts: 882

Re: help with doors
« Reply #2 on: Jun 24^th, 2017, 8:18pm »

For most cases you want to leave the "tenon length" at zero and set the "stile & rail cutter" to .375

The tenon length setting is added to the rail length without adding to the panel width.

The stile & rail cutter setting will also adjust the panel with.

Logged

Please remember this forum is for users to help each other. If you need a faster answer to a question email me directly.

n7kon
New Member

member is offline

Posts: 7

Re: help with doors
« Reply #3 on: Jun 28^th, 2017, 7:56pm »

Thanks, I knew it was something simple I was doing wrong.

Logged

Pages: 1


« Previous Topic \| Next Topic »