Cabinet Planner
General >> Cabinet Planner >> 3d view of "Type 2" cabinets
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1308676513

---

3d view of "Type 2" cabinets
Post by David on Jun 21^st, 2011, 11:15am

Rob,

From what I understand "Type 2" basically gives you a full width bottom without exposed sides.

I am trying to design a high set of cabinets with a finished bottom as they will be plainly visible.

When I render it still shows the sides running full height with the bottom protruding through the side.

The dimensions of the sides are shortened however. Is this just a glitch?

---

Re: 3d view of "Type 2" cabinets
Post by Rob on Jun 21^st, 2011, 1:31pm

Not really a glitch, just a lazy programmer

---

Re: 3d view of "Type 2" cabinets
Post by David on Jun 21^st, 2011, 2:41pm

ROFL ok so it is working properly dimensionally then? Thats all that matters.

---

Re: 3d view of "Type 2" cabinets
Post by Rob on Jun 21^st, 2011, 3:15pm

Yep, the parts lists will be correct. The 3d just draws type 1 & 2 the same way.

---