Welcome Guest. Please Login or Register. Mar 30th, 2018, 9:57pm
ATTENTION MEMBERS: Conforums will be closing it doors and discontinuing its service on April 15, 2018. We apologize Conforums does not have any export functions to migrate data. Ad-Free has been deactivated. Outstanding Ad-Free credits will be reimbursed to respective payment methods.
Question on panel layout
« Thread started on: Dec 14th, 2009, 7:16pm »
When I click on Calc, then doors, then panel layout, it shows all my stiles and rails in the 96 X 48 panel. I make the stiles and rails out of hardwood, I looked everywhere I could twice and don't see where to change the material from plywood to hardwood so they don't show on the panel layout.
I know it must be there but I just can't find it. This particular job is four panels, no cabinets.
Re: Question on panel layout
« Reply #1 on: Dec 14th, 2009, 9:12pm »
The length and width of the source material are editable. Change the 96 to the length of your board stock, then the 48 to the width of your board stock.
Re: Question on panel layout
« Reply #2 on: Dec 15th, 2009, 07:51am »
I'll look at that. I know you can do that, change the panel size. Once in a while I can get 5' X 7' baltic birch for $25, so I have done the size change.
My problem is the rails and stiles are showing up on the panel layout, when only the flat panels for doors and end panels should be.
Logged