Cabinet Planner: Beaded face frames

Cabinet Planner
General >> Cabinet Planner >> Beaded face frames
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1446832643

Beaded face frames
Post by kdelcas on Nov 6^th, 2015, 10:57am

Hello, New to the forum and relatively new to cabinet building. I apologize if this has already been asked.....tried searching buy didn't see anything. I am considering purchasing a Kreg Beaded face frame jig and building some custom flush inset door cabinets. Due to the fact that the face frame rail stock needs to be longer than a traditional butt joint to accommodate the "notch" for the bead, is there a way to have the program make that adjustment automatically so the cut list is accurate?

Re: Beaded face frames
Post by Rob on Nov 6^th, 2015, 11:54am

I believe the "face frame tenon length" setting in the General Standards will work for this.

Re: Beaded face frames
Post by kdelcas on Nov 6^th, 2015, 2:34pm

Awesome...thanks for the quick response. When make changes in general standards, do they stay with that project only?

Re: Beaded face frames
Post by Rob on Nov 6^th, 2015, 2:36pm

No, some of the settings are saved with each cabinet and some are not.