Cabinet Planner
General >> Cabinet Planner >> countertop problem
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1273338927

---

countertop problem
Post by ScottVroom on May 8^th, 2010, 11:15am

I have a 36" corner lazy susan. How do I set up the counter top to wrap around the corner? I tried using the Countertop Angle but couldn't get it to work.

Thanks-
Scott

---

Re: countertop problem
Post by Sandy Emerson on May 9^th, 2010, 11:54am

Hi, Scott -

When I do this I actually set up two adjacent walls at 90 degrees to each other. I then create the cabinet in the corner and top it with two straight countertops, one of them at position 0 (the intersection of the two walls) and the width of the one side of the cabinet (36" in this case). The other countertop is the width of the remainer on the other side (12" in this case) and is located at position 12 of the other wall. This will result in a good 3D rendering and elevation. Hope this helps. If you'd like I'll email you an example directly.

---