Cabinet Planner
General >> Cabinet Planner >> Stile width
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1453298803

---

Stile width
Post by jriggen on Jan 20^th, 2016, 07:06am

I need to make one of the middle stiles a different width than the other middle stiles. Is that possible? If so, how do I do that?

---

Re: Stile width
Post by Rob on Jan 20^th, 2016, 1:24pm

Depending on the cabinet type this can be done using the 'combined cabinets' feature. In the cabinet below the two side stiles are 2" the left middle one is 6" and the right middle one is 4"

---

Re: Stile width
Post by jriggen on Jan 21^st, 2016, 09:50am

Oops! Obviously I did not include enough information in my question. I didn't even get the terminology correct. My question is in regard to rails, not stiles.

I am designing a lower cabinet with 3 drawers and 1 breadboard. The top and bottom rails are 2". The 2 lower middle rails are each 2". I want the upper middle rail to be 1". This will leave openings of 5 1/4", 6 1/4", and 9 1/4" for the 3 drawers and 1 1/2" for the breadboard. How do I make this happen in CP?

Thanks for any and all help.

---

Re: Stile width
Post by Rob on Jan 21^st, 2016, 10:01am

Ah, Sorry no. The program is only able to have one width for the middle rails.

---