Cabinet Planner
General >> Cabinet Planner >> Blind corners
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1266449529
Blind corners
Post by rogers on Feb 17th, 2010, 4:32pm
In elevation view,When you add a blind corner cabinet to the next wall or previous wall,the the cabinet end shows up 23 1/4 instead of 24. I usually build my face frame the size of the total cabinet.Is there a way to change the face frame or at least have the end measurement show up 24. whew!!! don't know if anyone can understand this question but i'll give it a try.
Re: Blind corners
Post by Rob on Feb 17th, 2010, 9:34pm
Do you set the "blind end width" to zero for these? That should get the faceframe a little closer to coming out correct.
If that's what you do I should be able to check for it and then draw the cabinet at full depth on the adjacent wall.
Edit: nevermind, I just tried it and the doors/drawers would be wrong.
Re: Blind corners
Post by rogers on Feb 18th, 2010, 4:44pm
Rob
I set my blind end width to 24,the main thing I was trying to do was have the return on the next wall show up 24 instead of 23 1/4.I have been adding a 3/4 filler on the next wall, but all the measurements get kind of busy.But I love the program just trying to work a few kinks. Thanks.
Re: Blind corners
Post by Rob on Feb 19th, 2010, 1:14pm
I think the best way to fix this would be to add an option for a full width face frame. But, I've never built a blind cabinet like this. Can you send me a photo or drawing of how you build yours, with an explanation of how to designate where the stile would be located on the blind end of the cabinet.
Re: Blind corners
Post by rogers on Feb 19th, 2010, 3:03pm
Thanks Rob,but thats okay I thought there might be something simple I was just overlooking.It works just fine the way it is.