Cabinet Planner
General >> Cabinet Planner >> Question on panel layout
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1260843376

---

Question on panel layout
Post by RWL on Dec 14^th, 2009, 7:16pm

When I click on Calc, then doors, then panel layout, it shows all my stiles and rails in the 96 X 48 panel. I make the stiles and rails out of hardwood, I looked everywhere I could twice and don't see where to change the material from plywood to hardwood so they don't show on the panel layout.

I know it must be there but I just can't find it. This particular job is four panels, no cabinets.

Thanks in advance, what am i missing?

---

Re: Question on panel layout
Post by BrettA on Dec 14^th, 2009, 9:12pm

The length and width of the source material are editable. Change the 96 to the length of your board stock, then the 48 to the width of your board stock.

---

Re: Question on panel layout
Post by RWL on Dec 15^th, 2009, 07:51am

I'll look at that. I know you can do that, change the panel size. Once in a while I can get 5' X 7' baltic birch for $25, so I have done the size change.

My problem is the rails and stiles are showing up on the panel layout, when only the flat panels for doors and end panels should be.

---