Cabinet Planner: lazy susan base

Cabinet Planner
General >> Cabinet Planner >> lazy susan base
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1283308231

lazy susan base
Post by MIKESREYNOLDS on Aug 31^st, 2010, 8:30pm

When I draw a lazy susan base frameless 36x36 .70 sides and .25 back no dado and hit ok the drawing of the cutout is 12.25 x 12.25 the elevation width is 11.3. 11.3 +.7 side thickness =12 huh

? Maybe Im doing something wrong ,resp mike

Re: lazy susan base
Post by MarkL on Aug 31^st, 2010, 9:01pm

Where do you see a drawing of the cut out? I had trouble setting this up too. I ended up changing the left and right styles to 1.75 to accomodate the doors meeting at the face point when using a 170 degree hinge. I thing this will work, yet to move to the shop with this....

Re: lazy susan base
Post by Rob on Sep 1^st, 2010, 10:36pm

@Mike, that doesn't seem to add up. I will have to take a look and see what is happening there.

@Mark, with the elevation view closed, press the OK button in the editing window for a cabinet and the shop plan review window will open. This is handy if you want to print the shop plan for just one cabinet in a job.

Re: lazy susan base
Post by mjt on Sep 5^th, 2010, 3:02pm

I had the same problem. If I would have been paying attention I would have caught it before they were built. The corner cabinet ends up being 3/4" longer both ways, whether an upper or a lower. 24" upper ends up being 24 3/4 and 36" lower ends up 36 3/4" The program works fine for face frame, but not for frameless.