Cabinet Planner
General >> Say hello >> Hello from Hangtown and Coloma CA
http://cabplanner.conforums.com/index.cgi?board=introduce&action=display&num=1477162335

---

Hello from Hangtown and Coloma CA
Post by rpdb on Oct 22^nd, 2016, 12:52pm

Hello to all,

I am new to cabinet making. I purchased CP back in March after a trial. I have to renovate part of my wife's kitchen by removing a penninsula and running cabinets along a wall that is a bay window. I will need some help and advice if possible. I have two laundry rooms and a garage that need cabinets as well.
I drew the entire kitchen with CP, but I can't figure out how to draw in the new cabinets, and the best method to build them along the bay angles. Is there an easy method to exclude all the other cabinets, to only work on the ones I need to build?

Thanks,

Robert.

---

Re: Hello from Hangtown and Coloma CA
Post by Rob on Oct 22^nd, 2016, 9:41pm

Welcome to the forum!

Quote:

I drew the entire kitchen with CP, but I can't figure out how to draw in the new cabinets

You might take a look at some of the videos here, Http://www.cabinetplanner.com/tutorials.html

Quote:

and the best method to build them along the bay angles.

Adding cabinets to an angled wall takes a bit of trial & error to get them where they need to be.

Quote:

Is there an easy method to exclude all the other cabinets, to only work on the ones I need to build?

Each cabinet's editing window has a checkbox to exclude the cabinet from the cutlists and such.

---