Cabinet Planner
General >> Cabinet Planner >> Combining cabinets
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1429808283
Combining cabinets
Post by Woodjunkie4evr on Apr 23rd, 2015, 10:58am
Hello all.
So I have learned a lot so far but far from knowing enough. Lol
I have combined a lower base and a lower 4 drawer base
To end up with one cabinet that has 2 doors on the left and 4 drawers
On the right. All is well. Measurements seem correct now I have all settings correct.
My problem.
When creating a dxf. It will not draw the drawer slide holes on the divider between the door and the drawers but does on the side panel.
Is this normal or have I missed some thing.
Any help would be greatly appreciated.
Re: Combining cabinets
Post by Rob on Apr 26th, 2015, 10:19am
Sorry for not responding earlier.
I don't remember the reason now but I wasn't able to add the drawer slide holes for the combined cabinets when that feature was added.
I will have a look at it again.
Re: Combining cabinets
Post by Woodjunkie4evr on Apr 26th, 2015, 5:14pm
Thanks rob
If you can figure it out that would be great.
Even just having the holes still show up on both the sides
Would speed things up a bit as you could copy them much easier to the
Partition just by lining up the partition with the side in the tool pathing
Software.
And I guess it's really not a big deal right now either but takes a little
Extra time as you have to measure and place guides before you can
Copy the hole pattern To ensure their in the right place
Of course having the holes placed will saving the dxf would be awesome
Lol.
Waiting to here from you.
Thanks
Chris.