Cabinet Planner
General >> Cabinet Planner >> 3 Questions
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1358571800

---

3 Questions
Post by crash5050 on Jan 18^th, 2013, 10:03pm

1. is anybody using Aspire to cut cabinets from CP?
2. Can CP export an XLS file of the Cabinets
3. Is there a way to make the distance between the parts in the dfx files farther apart? I need to be able to group each part so that it stays intact when i nest it.

---

Re: 3 Questions
Post by Rob on Jan 18^th, 2013, 11:55pm

1. There are some but I don't know if they are members here. The dxf layer naming was specific setup for use with Aspire.

2. No. It does have a CSV output.

3. The part spacing is set with the "Width of saw kerf" setting in the first window that opens when calculating the panel layout.

---