Cabinet Planner: finished sides on shop drawings

Cabinet Planner
General >> Cabinet Planner >> finished sides on shop drawings
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1402937651

finished sides on shop drawings
Post by NickN on Jun 16^th, 2014, 10:54am

How do I change individual cabinets to show a u on the side instead of an f? This is causing confusion with my crew if I overlook editing the drawing with a note on it. So far, every cabinet is printed with an f on each side, except for blind corner units, which have a u. I would like to be able to change the designation per cabinet. Am I overlooking a setting?

Re: finished sides on shop drawings
Post by tagco on Jun 17^th, 2014, 6:09pm

A u is a scribe on the sides and a f is a finished end, no scribe. To show an f you have to set scribe left or right, amount to 0. I hope this helps!!