Cabinet Planner
General >> Cabinet Planner >> End Panel Depth w/Scribe
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1361201661

---

End Panel Depth w/Scribe
Post by Bergstrom on Feb 18^th, 2013, 08:34am

Is there a way to make the finished ends a different depth than the unfinished ends in Cabinet Planner? I have been manually adding 1/8" to my cutlists on finished ends for scribe and it just occured to me that the software may be capable of doing it and I just don't know how to set it up in the standards section.

---

Re: End Panel Depth w/Scribe
Post by Rob on Feb 18^th, 2013, 11:22am

No, not that I know of for normal cabinets.

I think for type 2 uppers it will do this. On sides that don't have scribe they are full cabinet depth minus the face frame. On sides that do have scribe the sides have the back thickness deducted also.

---