Cabinet Planner
General >> Cabinet Planner >> sides of cabinet
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1400182237

---

sides of cabinet
Post by ruthless1 on May 15^th, 2014, 1:30pm

ok Rob its me again but i just have an easy one for ya .... the sides of my cabinets the base units are coming out 3/4' shy of what they are supposed to be ... cabs are 30.5' tall and the cutlist says 29.75" so im not sure whats going on .. the standards are the same .. i went in and 0 out the toekick -.0001 and nothing changed and i cant seem to find any other standard to change .. whats different now ?

---

Re: sides of cabinet
Post by Rob on May 15^th, 2014, 2:47pm

-.001 (not -.0001) is for using separate toe kicks where the program shortens the length of the side so it stops at the bottom of the bottom instead of the bottom of the bottom rail.

If you want the sides to be the same length as the cabinet height, set the toe kick height to zero.

Two other settings can affect the length of the base sides.

If you have the dado depth set the same as the box material thickness then the sides are shortened so they sit on top of the bottom.

There is also the base cabinet side length adjustment.

---