Cabinet Planner
General >> Cabinet construction >> partition mounting in offset vanity?
http://cabplanner.conforums.com/index.cgi?board=construction&action=display&num=1490200171
partition mounting in offset vanity?
Post by androsi on Mar 22nd, 2017, 10:29am
So I am building my first offset vanity from CP. I am wondering how to mount the partition to the cabinet ? i was picturing it going from top to bottom and set in datos but CP makes the partition much shorter then this.
Re: partition mounting in offset vanity?
Post by Rob on Mar 22nd, 2017, 12:56pm
The shop plan will give the dado location for the partition if you want to put a dado in the cabinet bottom for it. Or you could screw it to the bottom from below. For the front you can either use pocket screws into the face frame or pin it though the front of the face frame.
The program keeps them short to eliminate any possible interference with the sink bowl.
Re: partition mounting in offset vanity?
Post by androsi on Mar 22nd, 2017, 3:10pm
Perfect ! thanks VM