Welcome Guest. Please Login or Register. Mar 30th, 2018, 9:31pm
ATTENTION MEMBERS: Conforums will be closing it doors and discontinuing its service on April 15, 2018. We apologize Conforums does not have any export functions to migrate data. Ad-Free has been deactivated. Outstanding Ad-Free credits will be reimbursed to respective payment methods.
Re: Bottom Size Problem
« Reply #2 on: Dec 11th, 2009, 07:57am »
Well, let me try again ... you gotta love computers!
Rob,
I designed a bar with all lower cabs and then printed off the layouts. When I was cutting the project I noticed that the bottoms were all 3/4" to long and hadn't been narrowed to allow for the back. I check the standards but couldn't see anything there to correct this. Is there something that I am missing?
Re: Bottom Size ProblemRob,
« Reply #3 on: Dec 11th, 2009, 10:27am »
For the bottom length it sounds like the “dado depth” is set to 3/8” and you don’t use dados. Go to the General Standards, set it to zero and then press the “Apply to current job” button.
Do you have a value entered for the “inset back depth”? This will decrease the depth of the bottoms.
Logged
Please remember this forum is for users to help each other. If you need a faster answer to a question email me directly.
Re: Bottom Size ProblemRob,
« Reply #4 on: Dec 11th, 2009, 2:05pm »
Rob,
The dado depth was the problem with the length. Thank you. The amount that back is recessed is set at 1/2" but isn't adjusting the width. I tried setting it to 3/4" and it took 1/4" off the width.
Logged
