Cabinet Planner
General >> Cabinet Planner >> How to add material to box panel optimizer
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1418099775

---

How to add material to box panel optimizer
Post by Dano on Dec 8^th, 2014, 9:36pm

I'm using the cabinet box's, box material panel layout optimizer. When I use "add" the window pops up-I enter a part size, hit add part and close it always show 0 x 0. I must then edit that part with the correct part size.
Then when I use method 1 to show parts layout on a sheet of plywood it comes up a blank page -nothing new added. Just the original parts. what am I doing wrong? I can add parts in all the other categories and it works fine.

---

Re: How to add material to box panel optimizer
Post by Rob on Dec 9^th, 2014, 8:01pm

I'm unable to duplicate this. Is anyone else?

---

Re: How to add material to box panel optimizer
Post by clweed on Feb 25^th, 2015, 11:58am

I am having the same problem, after entering dimensions ,qty etc. Hit save and close and the dimensions show up as 0 x 0

---

Re: How to add material to box panel optimizer
Post by Rob on Feb 26^th, 2015, 11:52am

I've checked into this again and just can't figure why this might be happening.

After you add the part and it shows the 0 x 0 size, can you select the part and edit it's sizes?

---