Cabinet Planner
General >> Cabinet Planner >> Inset doors
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1257170893

---

Inset doors
Post by taylorcabinet on Nov 2^nd, 2009, 07:08am

We have done a few jobs that are with inset doors and have a new one coming up. How do you the inset doors on program?

---

Re: Inset doors
Post by Rob on Nov 2^nd, 2009, 12:05pm

For inset doors, set the door overlay to zero or less. When it is zero or less, the program will automatically inset them in the 3D so they are flush with the front of the cabinet.

Typically you want about a 1/16 gap but it is usually best to build them so they are tight and them trim them to fit each opening as the doors or cabinet are never perfectly square.

---

Re: Inset doors
Post by taylorcabinet on Nov 3^rd, 2009, 5:03pm

Yes I did that, when I looked at the drawings they did not appear to look inset, but did not think to look at 3D view. Thanks

---