Cabinet Planner
General >> Cabinet Planner >> Glitch
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1298591611
Glitch
Post by NickB on Feb 24th, 2011, 4:53pm
I downloaded the latest update last night to play with the 3d rendering stuff.
I was in adjusting cabinets and the measurment that tells you where you are in the lower left hand corner is all jumbled and you cannot make out the numbers.
Nick
Re: Glitch
Post by trulycustom on Feb 24th, 2011, 5:53pm
Nick, Now that you mention it mine is the same. I did't say anything because I figured it was my machine.
kent
Re: Glitch
Post by NickB on Feb 24th, 2011, 6:30pm
Kent glad it wasn't just me too!
I also noticed that the mesurments along the top of the drawing are hidden unless you zoom out but then you can't drag another cabinet in unless you input its location.....
It would be nice for all the measurements to be visable and also to have them included going vertical.
Nick
Re: Glitch
Post by Pete on Feb 24th, 2011, 8:09pm
make that 3 too
Re: Glitch
Post by Rob on Feb 25th, 2011, 08:29am
Try it now. I moved the "loc" down to the status bar and reduced the initial elevation scale a little bit.
If anyone still has trouble with it send me a screen shot along with your monitor's screen resolution and DPI settings.
Re: Glitch
Post by trulycustom on Feb 25th, 2011, 09:43am
Rob, That fixed it for me!!! Thanks.
Kent
Re: Glitch
Post by NickB on Feb 25th, 2011, 9:48pm
Rob wasn't there a numeric scale (lower left hand side)that changed as you drag the mouse across the screen that tells you where you are in relation to the 0 start point of the wall?
All the numbers are clear now to see thank you! And also the length of the cabinet there when you drag it out.
Thanks,
Nick
Re: Glitch
Post by Rob on Feb 26th, 2011, 06:00am
Right, that's what I moved down to the status bar.
Re: Glitch
Post by NickB on Feb 26th, 2011, 10:07am
Ahhhhh yes you did!!
Thanks Rob guess I should have read your post better!! 
I was so accustom to it being in the other spot that I didn't notice it way down there!!
Thanks again!
Nick
Re: Glitch
Post by Rob on Feb 26th, 2011, 10:36am
