Cabinet Planner
General >> Cabinet Planner >> Top trim
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1274221325

---

Top trim
Post by Sligo on May 18^th, 2010, 4:22pm

Was drawing wall cabinets with flat trim board from top of cabinet to ceiling with crown on top . Used a valance to do this but can't get the ends. Is there a better way to do this.

---

Re: Top trim
Post by Rob on May 18^th, 2010, 4:48pm

Yes, you can use the Upper Filler with its height set to zero to place trim anywhere needed. When it's height is set to zero it will not be included in the material lists.

---