Cabinet Planner: Diffrent panel sizing

Cabinet Planner
General >> Cabinet Planner >> Diffrent panel sizing
http://cabplanner.conforums.com/index.cgi?board=general&action=display&num=1266505721

Diffrent panel sizing
Post by Chris on Feb 18^th, 2010, 08:08am

Rob
I was noticed when I check my material list it shows my cabinet sides , bottoms & shelfs all cut from the same sheet problem is my sides are 1/2" and my shelfs are 3/4" can I do something diffrent to seperate the two. Another question is I make thhe backs for my cabinets out of 1/2" and make them the same height as my sides 34 1/2" & 30" and dado them for my bottoms and tops of upper cabinets to insert in to. is this possible with this. rolleyes

Re: Diffrent panel sizing
Post by Rob on Feb 18^th, 2010, 08:28am

The program only supports one dimension for the thickness of the box and shelf parts.

For the backs you can set the thickness in the General Standards and use the Back Adjustments in the "More" window to correct for the size you need.