Cabinet Planner
General >> Say hello >> New guy
http://cabplanner.conforums.com/index.cgi?board=introduce&action=display&num=1300902168
New guy
Post by JonnyB on Mar 23rd, 2011, 11:42am
Hi all, JonnyB here!
Been using CP since ~2006 and just noticed the link to this forum under the help button, dooh. I think I know the program prety good but maybe there’s still something I'm not aware of. It sure has come a long way since i bought it.
Later,
JB
Re: New guy
Post by Pete on Mar 24th, 2011, 7:02pm
hey new guy ... well technically ... dont feel bad I miss the most obvious things!!!
Re: New guy
Post by Gene on Apr 1st, 2011, 12:39pm
Hey fellows,
I've used this program for a while now, but I got a problem. I'm designing a 3 opening tall cab. and I have to have the 3rd. rail from the top a differint width ( 31/8th ") in order to run a special mold across the cab. and continue it around the room. Our program list middle styles as one width only and I have to have two differing measurements. HELP!
Re: New guy
Post by BrettA on Apr 4th, 2011, 8:13pm
Gene,
Try this...Tall cabinet on the floor with one opening and adjust the top rail for 3-1/8inch. Stack a two opening on top with no base and adjust height to need. Do the math for the combined stiles and remove an extra top from bottom or the extra bottom from the top cab on the cut list. The picture should be correct.