Cabinet Planner
General >> General Discussion >> Finished Ends
http://cabplanner.conforums.com/index.cgi?board=Discussion&action=display&num=1308671482
Finished Ends
Post by jackie4097r on Jun 21st, 2011, 09:51am
Good Morning Rob,
I have a question about the finished ends. Why does the program add (f)finished ends on both sides of the cabinet? How do I make the program only put the finished ends on the open end sides, and or remove them off of the cabinets that are not on an open end?
Thanks
Jackie 
Re: Finished Ends
Post by Rob on Jun 21st, 2011, 10:10am
You can enter .001 for the scribe on your unfinished sides. That, along with using the "round to neartest 1/16" will still give the correct part sizes and it will show "U 0" on the shop plan.