09-08-2024, 10:49 PM
(09-08-2024, 10:11 PM)admin Wrote: The Stile and Rail length cutter depth is a setting that is saved along with each cabinet. When changing it in the Door standards be sure to hit the 'save and apply to current job' button.
That's not the issue with the settings. I am hitting save and apply to current job. With the current settings as I have them the upper door rails are fine and the base door rails are off by 1/2 and inch. If I then go in and adjust the cutter depth I can get the lowers to be correct and then the uppers are off.