Hi, I am trying to set up my printing and having some trouble.
I am building cabinets with face frames and a farmhouse design on a slab/inset door.
When I go to the Calc Window, it gives me the options of Material and Master List or Material and Panel Layout.
If I choose Layout, it only shows two pieces of the Poplar stock per page. These stock pieces are only 5" wide by 60" long.
I end up with 8 pages of layout cuts with only 20% of the page being used for printing.
How can I add more pieces to the Layout so I am not wasting so much printer paper?
Thank you,
MD
I am building cabinets with face frames and a farmhouse design on a slab/inset door.
When I go to the Calc Window, it gives me the options of Material and Master List or Material and Panel Layout.
If I choose Layout, it only shows two pieces of the Poplar stock per page. These stock pieces are only 5" wide by 60" long.
I end up with 8 pages of layout cuts with only 20% of the page being used for printing.
How can I add more pieces to the Layout so I am not wasting so much printer paper?
Thank you,
MD