05-07-2026, 10:31 PM
Hi
I have a base cabinet that is 24" wide and 18" deep using 3/4 plywood which is being assembled with pocket hole screws. When calculate the panel cutlist the bottom panel is 23 1/4 x 17 1/2. The depth of the panel is correct at 17 1/2 but the width should be 22. I set any dado setting to 0 but I must be missing another setting somewhere. I typically build my face frame 24" wide which extends 1/4 beyond the cabinet on both sides. So the interior dimension of the bottom panel would be 22x17 1/4, but the dimension I see in my cutlist is 23 1/4 x 17 1/4. Am I missing a setting or should I be doing something differently?
Thanks
I have a base cabinet that is 24" wide and 18" deep using 3/4 plywood which is being assembled with pocket hole screws. When calculate the panel cutlist the bottom panel is 23 1/4 x 17 1/2. The depth of the panel is correct at 17 1/2 but the width should be 22. I set any dado setting to 0 but I must be missing another setting somewhere. I typically build my face frame 24" wide which extends 1/4 beyond the cabinet on both sides. So the interior dimension of the bottom panel would be 22x17 1/4, but the dimension I see in my cutlist is 23 1/4 x 17 1/4. Am I missing a setting or should I be doing something differently?
Thanks