Removing knobs and pulls on Tall Custom

[Mike_d_s]

Laying out a tall custom for a customer and I'm trying to remove the door and drawer hardware.  For a normal tall cabinet there is a door hardware button, but I don't see it for the tall custom.

There are 'More' and 'Openings' buttons to configure the materials and door/drawer types for the custom, but I can't see the way to remove the knobs and pulls. I attached a screen shot of the menu for the Tall Custom.

Am I doing something wrong or somehow missing the button?

Thanks,
Mike

[admin]

In the General Standards, erase what you have for the hardware for the doors (and drawers also if needed). This is the setting the Tall Custom uses.

   

[Mike_d_s]

OK, That did it.

As I side note, I did have to go into the cabinet and save it to force the re-render in the elevation view. But I'm sure it would have worked the same had I changed views.

Thanks for the prompt response.

Mike